Table of Contents
Advertisement
KVM over IP User Manual
click on the Refresh-button. If locally managed, the timeout can be changed on
the fly without affecting any other settings.
Max. Datagram Size:
The maximum number of data bytes that can be sent in a single sample
datagram. This should be set to a value that avoids fragmentation of the sFlow
datagrams. Valid range is 200 to 1468 bytes with default being 1400 bytes.
Port Configuration
Port:
The port number for which the configuration below applies.
Flow Sampler Enabled:
Enables/disables flow sampling on this port.
Flow Sampler Sampling Rate:
The statistical sampling rate for packet sampling. Set to N to sample on average
1/Nth of the packets transmitted/received on the port.
Not all sampling rates are achievable. If an unsupported sampling rate is
requested, the switch will automatically adjust it to the closest achievable. This
will be reported back in this field.
Flow Sampler Max. Header:
The maximum number of bytes that should be copied from a sampled packet
to the sFlow datagram. Valid range is 14 to 200 bytes with default being 128
bytes.
If the maximum datagram size does not take into account the maximum header
size, samples may be dropped.
Counter Poller Enabled:
Enables/disables counter polling on this port.
Counter Poller Interval:
With counter polling enabled, this specifies the interval - in seconds - between
counter poller samples.
Buttons
Apply:
Click to save changes.
Reset:
418
Advertisement
Table of Contents
