Table of Contents
Advertisement
Hours - Select the ending hour.
Minutes - Select the starting minute.
Offset settings:
Offset - Enter the number of minutes to add during Daylight Saving Time.
(Range: 1 to 1440)
Note: The under "Start Time Settings" and "End Time Settings" was displayed
what you set on the "Start Time Settings" and "End Time Settings" field
information.
Buttons
Apply:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously saved values.
Configure NTP Server:
Click to configure NTP server, When Clock Source select from NTP Server.
NTP is Network Time Protocol and is used to sync the network time based
Greenwich Mean Time (GMT). If use the NTP mode and select a built-in NTP
time server or manually specify an user-defined NTP server as well as Time
Zone, the switch will sync the time in a short after pressing <Apply> button.
Chapter 3. System
35
Advertisement
Table of Contents
