Table of Contents
Advertisement
KVM over IP User Manual
• If sFlow is currently configured through SNMP, Owner contains a string
identifying the sFlow receiver.`
IP Address/Hostname:
The IP address or hostname of the sFlow receiver.
Timeout:
The number of seconds remaining before sampling stops and the current sFlow
owner is released.
Tx Successes:
The number of UDP datagrams successfully sent to the sFlow receiver.
Tx Errors:
The number of UDP datagrams that has failed transmission.
The most common source of errors is invalid sFlow receiver IP/hostname
configuration. To diagnose, paste the receiver's IP address/hostname into the
Ping Web page (Diagnostics → Ping/Ping6).
Flow Samples:
The total number of flow samples sent to the sFlow receiver.
Counter Samples:
The total number of counter samples sent to the sFlow receiver.
Port Statistics
Port:
The port number for which the following statistics applies.
Rx and Tx Flow Samples:
The number of flow samples sent to the sFlow receiver originating from this
port. Here, flow samples are divided into Rx and Tx flow samples, where Rx
flow samples contains the number of packets that were sampled upon reception
(ingress) on the port and Tx flow samples contains the number of packets that
were sampled upon transmission (egress) on the port.
Counter Samples:
The total number of counter samples sent to the sFlow receiver originating
from this port.
Buttons
420
Advertisement
Table of Contents
