ATEN ES0152 User Manual page 38

KVM over IP User Manual
2. Click Add Interface then you can create new Interface on the switch.
3. Click Add Route then you can create new Route on the switch.
4. Click Apply.
 Parameter description:
Basic Setting
Mode:
Configure whether the IP stack should act as a Host or a Router. In Host mode,
IP traffic between interfaces will not be routed. In Router mode traffic is routed
between all interfaces.
DNS Server:
This setting controls the DNS name resolution done by the switch.
There are four servers available for configuration, and the index of the server
presents the preference (less index has higher priority) in doing DNS name
resolution.
The following modes are supported:
 No DNS server
No DNS server will be used.
 Configured IPv4
Explicitly provide the valid IPv4 unicast address of the DNS Server
in dotted decimal notation.
Make sure the configured DNS server could be reachable (e.g. via PING)
for activating DNS service.
 Configured IPv6
Explicitly provide the valid IPv6 unicast (except linklocal) address of the
DNS Server.
Make sure the configured DNS server could be reachable (e.g. via PING6)
for activating DNS service.
 From any DHCPv4 interfaces
The first DNS server offered from a DHCPv4 lease to a DHCPv4-enabled
interface will be used.
 From this DHCPv4 interface
Specify from which DHCPv4-enabled interface a provided DNS server
should be preferred.
 From any DHCPv6 interfaces
24