Table of Contents
Advertisement
KVM over IP User Manual
7. If you want to cancel the setting then you need to click the Reset button. It
will revert to previously saved values
Parameter description:
MVR Mode:
Enable/Disable the Global MVR.
The Unregistered Flooding control depends on the current configuration in
IGMP/MLD Snooping. It is suggested to enable Unregistered Flooding control
when the MVR group table is full.
MVR VID:
Specify the Multicast VLAN ID.
Be Caution: MVR source ports are not recommended to be overlapped with
management VLAN ports.
MVR Name:
MVR Name is an optional attribute to indicate the name of the specific MVR
VLAN. Maximum length of the MVR VLAN Name string is 32. MVR VLAN
Name can only contain alphabets or numbers. MVR VLAN name can be edited
for the existing MVR VLAN entries or it can be added to the new entries.
IGMP Address:
Define the IPv4 address as source address used in IP header for IGMP control
frames.
The default IGMP address is not set (0.0.0.0).
When the IGMP address is not set, system uses IPv4 management address of
the IP interface associated with this VLAN.
When the IPv4 management address is not set, system uses the first available
IPv4 management address.
Otherwise, system uses a pre-defined value. By default, this value will be
192.0.2.1.
Mode:
Specify the MVR mode of operation. In Dynamic mode, MVR allows dynamic
MVR membership reports on source ports. In Compatible mode, MVR
membership reports are forbidden on source ports. The default is Dynamic
mode.
Tagging:
236
Advertisement
Table of Contents
