Table of Contents
Advertisement
Chapter 12. Security
5. Set EAPOL Timeout (Default is 30 seconds).
6. Set Aging Period (Default is 300 seconds).
7. Set Hold Time (Default is 10 seconds).
8. Checked RADIUS-Assigned QoS Enabled.
9. Checked RADIUS-Assigned VLAN Enabled.
10. Checked Guest VLAN Enabled.
11. Specify Guest VLAN ID.
12. Specify Max. Reauth. Count.
13. Checked Allow Guest VLAN if EAPOL Seen.
14. Select Admin State and displays Port State.
15. Click the Apply to save the setting.
16. If you want to cancel the setting then you need to click the Reset button. It
will revert to previously saved values.
Parameter description:
System Configuration
Mode:
on or off.
Indicates if IEEE 802.1X is globally enabled or disabled on the switch. If
globally disabled, all ports are allowed forwarding of frames.
Reauthentication Enabled:
If checked, successfully authenticated supplicants/clients are reauthenticated
after the interval specified by the Reauthentication Period. Reauthentication
for 802.1X-enabled ports can be used to detect if a new device is plugged into
a switch port or if a supplicant is no longer attached.
For MAC-based ports, reauthentication is only useful if the RADIUS server
configuration has changed. It does not involve communication between the
switch and the client, and therefore doesn't imply that a client is still present on
a port (see Aging Period below).
Reauthentication Period:
Determines the period, in seconds, after which a connected client must be
reauthenticated. This is only active if the Reauthentication Enabled checkbox
is checked. Valid values are in the range 1 to 3600 seconds.
281
Advertisement
Table of Contents
