Table of Contents
Advertisement
KVM over IP User Manual
Modification Buttons:
You can modify each ACE (Access Control Entry) in the table using the
following buttons:
: Inserts a new ACE before the current row.
: Edits the ACE row.
: Moves the ACE up the list.
: Moves the ACE down the list.
: Deletes the ACE.
: The lowest plus sign adds a new entry at the bottom of the ACE listings.
ACE Configuration
An ACE consists of several parameters. These parameters vary according to
the frame type that you select. First select the ingress port for the ACE, and then
select the frame type. Different parameter options are displayed depending on
the frame type selected.
A frame that hits this ACE matches the configuration that is defined here.
Ingress Port:
Select the ingress port for which this ACE applies.
All: The ACE applies to all port.
Port n: The ACE applies to this port number, where n is the number of the
switch port.
Policy Filter:
Specify the policy number filter for this ACE.
Any: No policy filter is specified. (policy filter status is "don't-care".)
Specific: If you want to filter a specific policy with this ACE, choose this
value. Two field for entering an policy value and bitmask appears.
Policy Value:
When "Specific" is selected for the policy filter, you can enter a specific policy
value. The allowed range is 0 to 255.
Policy Bitmask:
When "Specific" is selected for the policy filter, you can enter a specific policy
bitmask. The allowed range is 0x0 to 0xff. Notice the usage of bitmask, if the
binary bit value is "0", it means this bit is "don't-care". The real matched
pattern is [policy_value & policy_bitmask]. For example, if the policy value is
3 and the policy bitmask is 0x10(bit 0 is "don't-care" bit), then policy 2 and 3
are applied to this rule.
Frame Type:
340
Advertisement
Table of Contents
