Table of Contents
Advertisement
Chapter 10. Multicast
The flooding control takes effect only when MLD Snooping is enabled.
When MLD Snooping is disabled, unregistered IPMCv6 traffic flooding is
always active in spite of this setting.
MLD SSM Range:
SSM (Source-Specific Multicast) Range allows the SSM-aware hosts and
routers run the SSM service model for the groups in the address (Using IPv6
Address) range.
Leave Proxy Enabled:
Enable MLD Leave Proxy. This feature can be used to avoid forwarding
unnecessary leave messages to the router side.
Proxy Enabled:
Enable MLD Proxy. This feature can be used to avoid forwarding unnecessary
join and leave messages to the router side.
Port Related Configuration
Router Port:
Specify which ports act as router ports. A router port is a port on the Ethernet
switch that leads towards the Layer 3 multicast device or MLD querier. If an
aggregation member port is selected as a router port, the whole aggregation
will act as a router port.
Fast Leave:
To evoke to enable the fast leave on the port.
Throttling:
Enable to limit the number of multicast groups to which a switch port can
belong.
Filtering Profile:
You can select profile when you edit in Multicast Filtering Profile.
Buttons
Apply:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously saved values.
225
Advertisement
Table of Contents
