Table of Contents
Advertisement
Chapter 16. Event Notification
3. Click apply to save the setting.
4. If you want to cancel the setting then you need to click the Reset button. It
will revert to previously saved values.
Parameter description:
Agent Configuration
IP Address:
The IP address used as Agent IP address in sFlow datagrams. It serves as a
unique key that will identify this agent over extended periods of time.
Both IPv4 and IPv6 addresses are supported.
Receiver Configuration
Owner:
Basically, sFlow can be configured in two ways: Through local management
using the Web or CLI interface or through SNMP. This read-only field shows
the owner of the current sFlow configuration and assumes values as follows:
• If sFlow is currently unconfigured/unclaimed, Owner contains <none>.
• If sFlow is currently configured through Web or CLI, Owner contains
<Configured through local management>.
• If sFlow is currently configured through SNMP, Owner contains a string
identifying the sFlow receiver.
If sFlow is configured through SNMP, all controls - except for the Release-
button - are disabled to avoid inadvertent reconfiguration.
The Release button allows for releasing the current owner and disable sFlow
sampling. The button is disabled if sFlow is currently unclaimed. If configured
through SNMP, the release must be confirmed (a confirmation request will
appear).
IP Address/Hostname:
The IP address or hostname of the sFlow receiver. Both IPv4 and IPv6
addresses are supported.
UDP Port:
The UDP port on which the sFlow receiver listens to sFlow datagrams. If set to
0 (zero), the default port (6343) is used.
Timeout:
The number of seconds remaining before sampling stops and the current sFlow
owner is released. While active, the current time left can be updated with a
417
Advertisement
Table of Contents
