Table of Contents
Advertisement
KVM over IP User Manual
Trap Mode:
Indicates the SNMP mode operation. Possible modes are:
on: Enable SNMP mode operation.
off: Disable SNMP mode operation.
Trap Version:
Indicates the SNMP supported version. Possible versions are:
SNMP v1: Set SNMP supported version 1.
SNMP v2c: Set SNMP supported version 2c.
SNMP v3: Set SNMP supported version 3.
Trap Community:
Indicates the community access string when sending SNMP trap packet. The
allowed string length is 0 to 63, and the allowed content is ASCII characters
from 33 to 126.
Trap Destination Address:
Indicates the SNMP trap destination address. It allow a valid IP address in
dotted decimal notation ('x.y.z.w').
And it also allow a valid hostname. A valid hostname is a string drawn from
the alphabet (A-Za-z), digits (0-9), dot (.), dash (-). Spaces are not allowed, the
first character must be an alpha character, and the first and last characters must
not be a dot or a dash.
Indicates the SNMP trap destination IPv6 address. IPv6 address is in 128-bit
records represented as eight fields of up to four hexadecimal digits with a colon
separating each field (:). For example, 'fe80::215:c5ff:fe03:4dc7'. The symbol
'::' is a special syntax that can be used as a shorthand way of representing
multiple 16-bit groups of contiguous zeros; but it can appear only once. It can
also represent a legally valid IPv4 address. For example, '::192.1.2.34'.
Trap Destination port:
Indicates the SNMP trap destination port. SNMP Agent will send SNMP
message via this port, the port range is 1~65535.
Trap Security Engine ID:
Indicates the SNMP trap security engine ID. SNMPv3 sends traps and informs
using USM for authentication and privacy. A unique engine ID for these traps
and informs is needed. When "Trap Probe Security Engine ID" is enabled, the
ID will be probed automatically. Otherwise, the ID specified in this field is
396
Advertisement
Table of Contents
