KVM over IP User Manual
Parameter description:
Port:
The switch port number of the logical STP port.
STP Enabled:
Controls whether STP is enabled on this switch port. This field will be read
only if Voice VLAN feature is enabled. The Voice VLAN port mode will be
read only if this field be Enabled.
Path Cost:
Controls the path cost incurred by the port. The Auto setting will set the path
cost as appropriate by the physical link speed, using the 802.1D recommended
values. Using the Specific setting, a user-defined value can be entered. The
path cost is used when establishing the active topology of the network. Lower
path cost ports are chosen as forwarding ports in favor of higher path cost ports.
Valid values are in the range 1 to 200000000.
Priority:
Controls the port priority. This can be used to control priority of ports having
identical port cost. (See above).
AdminEdge:
Controls whether the operEdge flag should start as set or cleared. (The initial
operEdge state when a port is initialized).
AutoEdge:
194