Table of Contents
Advertisement
Chapter 6. VLAN Management
5. Click apply to save the setting.
6. If you want to cancel the setting then you need to click the Reset button. It
will revert to previously saved values.
Parameter description:
Enable GVRP globally:
The GVRP feature is enabled by setting the check mark in the checkbox named
Enable GVRP.
GVRP protocol timers:
Join-time is a value in the range 1-20 in the units of centi seconds, i.e. in units
of one hundredth of a second. The default is 20.
Leave-time is a value in the range 60-300 in the units of centi seconds, i.e. in
units of one hundredth of a second. The default is 60.
Leave All-time is a value in the range 1000-5000 in the units of centi seconds,
i.e. in units of one hundredth of a second. The default is 1000.
Max VLANs:
When GVRP is enabled a maximum number of VLANs supported by GVRP
is specified. By default this number is 20. This number can only be changed
when GVRP is turned off.
Port:
The Port column shows the list of ports.
Mode:
This configuration is to enable/disable GVRP Mode on particular port locally.
Disable: Select to Disable GVRP mode on this port.
GVRP Enable: Select to Enable GVRP mode on this port.
Buttons
Apply:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously saved values.
137
Advertisement
Table of Contents
