Table of Contents
Advertisement
KVM over IP User Manual
Authentication Method can be set to one of the following values:
none: authentication is disabled and login is not possible.
local: use the local user database on the switch for authentication.
radius: use a remote RADIUS server for authentication.
tacacs: use a remote TACACS server for authentication.
Methods that involves remote servers are timed out if the remote servers are
offline. In this case the next method is tried. Each method is tried from left to
right and continues until a method either approves or rejects a user. If a remote
server is used for primary authentication it is recommended to configure
secondary authentication as 'local'. This will enable the management client to
login via the local user database if none of the configured authentication
servers are alive.
Service Port:
The TCP port for each client service. The valid port number is 1 ~ 65534.
HTTP Redirect:
Enable http Automatic Redirect.
Command Authorization Method Configuration
Client:
The management client for which the configuration below applies.
Method:
Authorization Method can be set to one of the following values:
none: authorization is disabled and login is not possible.
tacacs: use a remote TACACS+ server for authorization.
Cmd Lvl:
Runs authorization for all commands at the specified privilege level. Specific
command level that should be authorized. Valid entries are 0 through 15.
Cfg Cmd:
Enable or disable the configure command.
Fallback:
274
Advertisement
Table of Contents
