ATEN ES0152 User Manual page 191

52-port gbe poe managed switch
Hide thumbs Also See for ES0152:
Table of Contents

Advertisement

Chapter 7. Quality of Server (QoS)
Inner Tag Value of Inner Tag field can be 'Untagged', 'Tagged', 'C-Tagged', 'S-
Tagged' or 'Any'.
Inner VID Valid value of Inner VLAN ID can be any value in the range 1-4095
or 'Any'; user can enter either a specific value or a range of VIDs.
Inner PCP Valid value of Inner PCP are specific (0, 1, 2, 3, 4, 5, 6, 7) or range
(0-1, 2-3, 4-5, 6-7, 0-3, 4-7) or 'Any'.
Inner DEI Valid value of Inner DEI can be '0', '1' or 'Any'.
Frame Type Frame Type can have any of the following values:
Any
EtherType
LLC
SNAP
IPv4
IPv6
Note: All frame types are explained below.
Any:
Allow all types of frames.
EtherType:
Ether Type Valid Ether Type can be 0x600-0xFFFF excluding 0x800(IPv4)
and 0x86DD(IPv6) or 'Any'.
LLC:
DSAP Address Valid DSAP(Destination Service Access Point) can vary from
0x00 to 0xFF or 'Any'.
SSAP Address Valid SSAP(Source Service Access Point) can vary from 0x00
to 0xFF or 'Any'.
Control Valid Control field can vary from 0x00 to 0xFF or 'Any'.
SNAP:
PID Valid PID(a.k.a Ether Type) can be 0x0000-0xFFFF or 'Any'.
IPv4:
Protocol IP protocol number: (0-255, 'TCP' or 'UDP') or 'Any'.
Source IP Specific Source IP address in value/mask format or 'Any'. IP and
Mask are in the format x.y.z.w where x, y, z, and w are decimal numbers
between 0 and 255. When Mask is converted to a 32-bit binary string and read
from left to right, all bits following the first zero must also be zero.
177

Advertisement

Table of Contents
loading

This manual is also suitable for:

Es0152p

Table of Contents