Communication Function Via Peripheral I/F; Direct Connection - Mitsubishi Electric Q Series Programming Manual

4 AUXILIARY AND APPLIED FUNCTIONS

4.13 Communication Function via PERIPHERAL I/F

4.13.1 Direct connection

The built-in Ethernet Motion CPU (Q173DSCPU /Q172DSCPU/Q173DCPU-S1/
Q172DCPU-S1) can communicate data by connecting built-in PERIPHERAL I/F of the
Motion CPU with personal computers and/or display devices, etc. using an Ethernet
cable.
There are following three ways to communicate between the Motion CPU and
MT Developer2.
• "Direct connection" connected with the Ethernet cable
• "Connection via HUB" connected via HUB
• MC protocol communication
Ver.! : Refer to Section 1.5 for the software version that supports this function.
Between the Motion CPU and MT Developer2 can be connected using one Ethernet
cable without HUB.
The direct connection enables communication with only specifying connection target.
IP address setting is not required.
Ver.!
Ethernet cable (Crossover cable)
PERIPHERAL I/F
4 - 63
MT Developer2