Mitsubishi Electric Q Series Programming Manual page 234

APPENDICES
No. Name
Clock data read
SM801
request
Rapid stop
deceleration time
SM805
setting error invalid
flag Ver.!
(Note-1): It is used for interlock condition of Multiple CPU high speed bus dedicated instruction when a synchronous system
set in Multiple CPU synchronous startup setting of system setting.
(Note-2): The CPU No.1 is reset after the factor of the stop error is removed to cancel a stop error  Resetting is cancelled.
Table 1.1 Special relay list (Continued)
Meaning
OFF : Ignored • When this relay is ON, clock data is read to SD210 to
ON : Read request
• When this relay is ON, the large value than deceleration time
OFF : Setting error valid
ON : Setting error invalid
Ver.! : Refer to Section 1.5 for the software version that supports this function.
Details
SD213 as BCD values.
can be set as rapid stop deceleration time. (The servo
program setting error (error code: 51) will not occur.)
APP - 5
Set by
Remark
(When set)
U