Mitsubishi Electric Q Series Programming Manual page 122

4 AUXILIARY AND APPLIED FUNCTIONS
(b) Usable devices
Item
(Note-1)
Input relay
Output relay
Internal relay
Link relay
Annunciator
Special relay
Multiple CPU area device
(Note-1): The real input range(PX) is included.
(Note-2): The range of "PXn+4 to PXn+F" cannot be used (fixed at 0) for the input
device (PXn+0 to PXn+F) allocated to the built-in interface in Motion CPU
(DI). (n: First input No.)
(Note-3): The real input range(PY) is included.
(Note-4): "p" indicates the user setting area points of the Multiple CPU high speed
transmission area for each CPU.
(5) Forced output bit
(a) Set the "forced output bit" when you want to forcibly provide the limit switch
outputs during operation.
The following control is exercised.
Output enable/disable bit
Without setting
With setting
(b) Usable devices
Item
Input relay
Output relay
Internal relay
Link relay
Annunciator
Special relay
Multiple CPU area device
(Note-1): The range of "PXn+4 to PXn+F" cannot be used (fixed at 0) for the input
device (PXn+0 to PXn+F) allocated to the built-in interface in Motion CPU
(DI). (n: First input No.)
(Note-2): "p" indicates the user setting area points of the Multiple CPU high speed
transmission area for each CPU.
POINT
Refer to Chapter 2 for the user setting area points of the Multiple CPU high speed
transmission area.
(Note-3)
U \G10000.0 to U \G (10000+p-1).F
QDS
Limit switch outputs are turned ON/OFF on the basis
of the "output enable/disable bit" and ON section
OFF
setting (ON Value, OFF Value).
ON Limit switch outputs are turned ON.
U \G10000.0 to U \G (10000+p-1).F
QDS
4 - 7
Device No. setting range
(Note-2)
X0 to X1FFF
Y0 to Y1FFF
M0 to M8191
B0 to B1FFF
F0 to F2047
SM0 to SM1999
Control description
Device No. setting range
(Note-1)
X0 to X1FFF
Y0 to Y1FFF
M0 to M8191
B0 to B1FFF
F0 to F2047
SM0 to SM1999
(Note-4)
(Note-2)