Servo Parameters - Mitsubishi Electric Q Series Programming Manual

3 COMMON PARAMETERS

3.3 Servo Parameters

Servo amplifier type
MR-J4- B
MR-J4W- B
MR-J3- B
MR-J3W- B
MR-J3- B-RJ004
MR-J3- B-RJ006
MR-J3- B-RJ080W
MR-J3- B Safety
The servo parameters control the data fixed by the specifications of the servo amplifier
and servomotor controlled in the parameter set for each axis and the control of the
servomotor.
The servo parameters are set by the Setup software (MR Configurator ).
Refer to the "Servo amplifier Instruction Manual" for details of the servo parameters.
Refer to the help for handling of MR Configurator .
Servo amplifier Instruction Manual list is shown below.
SSCNET /H interface MR-J4- B Servo amplifier Instruction Manual (SH-030106)
SSCNET /H interface Multi-axis AC Servo MR-J4W- B Servo amplifier Instruction
Manual (SH-030105)
SSCNET interface MR-J3- B Servo amplifier Instruction Manual (SH-030051)
SSCNET interface 2-axis AC Servo Amplifier MR-J3W- B Servo amplifier Instruction
Manual (SH-030073)
SSCNET Compatible Linear Servo MR-J3- B-RJ004 Instruction Manual (SH-030054)
SSCNET Compatible Fully Closed Loop Control MR-J3- B-RJ006 Servo amplifier
Instruction Manual (SH-030056)
SSCNET interface Direct Drive Servo MR-J3- B-RJ080W Servo amplifier Instruction
Manual (SH-030079)
SSCNET interface Drive Safety integrated MR-J3- B Safety Servo amplifier Instruction
Manual (SH-030084)
POINTS
When the parameter that should turn on servo amplifier power supply again is
changed, make the Multiple CPU system reset or power supply OFF to ON. And,
once turn OFF the servo amplifier's power supply and then turn ON it again.
Instruction manual name
3 - 25