Starting Up The Multiple Cpu System; Startup Flow Of The Multiple Cpu System - Mitsubishi Electric Q Series Programming Manual

2 MULTIPLE CPU SYSTEM

2.2 Starting Up the Multiple CPU System

2.2.1 Startup Flow of the Multiple CPU system

PLC CPU
Motion CPU
PLC CPU
This section describes a standard procedure to start up the Multiple CPU system.
START
Definition of functions with Multiple CPU
system
Control and function executed in each
CPU module are defined.
Application and assignment of device
When automatic refresh of the CPU
shared memory is performed, the
number of refresh points is continuously
obtained.
Selection of module
Select the module to achieve the
function with the Multiple CPU system.
Installation of module
Install the selected module on the main
base unit and extension base unit.
Start-up of GX Works2/GX Developer
Start-up GX Works2 (Ver.1.15R or later)
/GX Developer (Ver. 8.48A or later).
Creation of parameters, etc.
Create the parameter such as Multiple
CPU setting and control CPU setting,
and the sequence program.
Connection of PC to the PLC CPU
module of CPU No. 1
Connect the PC that started GX Works2
/GX Developer to the PLC CPU module
of CPU No. 1 with the RS-232/USB/
Ethernet cable.
Multiple CPU system power ON
Turn ON the power of Multiple CPU
system in the following state of PLC
CPU module of CPU No.1.
RUN/STOP/RESET switch : STOP
Write of parameter and program
Write parameter and sequence program
in the PLC CPU of CPU No. 1.
For PLC CPU other than CPU No. 1,
select the applicable PLC CPU by
specifying the connection.
1)
Refer to Section 2.3
Refer to the "Q173D(S)CPU/Q172D(S)CPU
Motion controller User's Manual"
Refer to the "Q173D(S)CPU/Q172D(S)CPU
Motion controller User's Manual"
Refer to the GX Works2/GX Developer Manual.
Create the parameters for CPU No. 1 to 4 and
sequence programs.
Refer to the "QnUCPU User's Manual" (Function
Explanation/Program Fundamentals)".
2 - 10