Communication Via Network; Specifications Of The Communications Via Network - Mitsubishi Electric Q Series Programming Manual

4 AUXILIARY AND APPLIED FUNCTIONS

4.7 Communication Via Network

4.7.1 Specifications of the communications via network

The communication between the personal computer and the Motion CPU is possible
via Q series Network module (CC-LinkIE, CC-Link, MELSECNET/10(H), Ethernet and
etc.) in the Motion CPU module.
Refer to the PLC manuals for the specifications of each network modules of
CC-LinkIE, CC-Link, MELSECNET/10(H), Ethernet and Serial communication, the
handling method.
(1) Communications via network enables using MT Developer2 in the Motion CPU.
(2) Access range of the communications via network of the Motion CPU is an access
range equivalent to connection PLC CPU using GX Works2/GX Developer.
Refer to the operating manual of GX Works2/GX Developer for details.
(3) By setting the routing parameter to the control CPU of the network module and the
CPU which connected the peripheral devices in the network by
MELSECNET/10(H) and Ethernet, it is possible to relay to 8 network points and
communicate.
(4) Because the Motion CPU cannot become the control CPU of the network module,
there is not setting item of the network module and network parameter.
However, when connecting with the CPU on the other network from the peripheral
device which connected the Motion CPU, it needs to the setting of the routing
parameter.
(5) It can operate by remote control the monitor or program editing of the Motion CPU
via the intranet using the Ethernet module.
Personal Computer
Power QnUD Q173 D(S)
CPU
supply CPU
Personal Computer
Ethernet
Intranet
Ethernet
module
4 - 44
Ethernet
Power QnUD Q173 D(S)
CPU
supply CPU
Ethernet
module