Operations (Sv22 Advanced Synchronous Control Only) - Mitsubishi Electric Q Series Programming Manual

4 AUXILIARY AND APPLIED FUNCTIONS

4.1.3 Operations (SV22 advanced synchronous control only)

(1) ON output to an output device is made while the watch data value is in the ON
region set with lower limit value and upper limit value in the limit switch output
function.
Up to two ON regions can be set for each limit output setting data.
(a) Lower limit value, upper limit value and watch data value are handled as
signed data.
ON output region where an ON output is made to the output device is
governed by the magnitude relationship between lower limit value and upper
limit value as indicated below.
Relationship between lower limit value and
upper limit value
Lower limit value < Upper limit value
Lower limit value > Upper limit value
Lower limit value = Upper limit value
1) Lower limit value < Upper limit value
Output device
ON section setting
Watch data value
2) Lower limit value > Upper limit value
Output device
ON section setting
Watch data value
(Watch data value) < Upper limit value
3) Lower limit value = Upper limit value
Output device
ON section setting
Watch data value
Ver.! : Refer to Section 1.5 for the software version that supports this function.
Lower limit value  (watch data value) < Upper
limit value
Lower limit value  (watch data value)
(Watch data value) < Upper limit value
Output OFF in whole region
ON
OFF
Upper limit value
Lower limit value
Lower limit value < (Watch data value) < Upper limit value
ON
OFF
Upper limit value
Lower limit value
OFF in whole region
Lower limit value Upper limit value
4 - 8
Ver.!
QDS
ON output region
OFF
ON
Lower limit value < (Watch data value)