Mitsubishi Electric Q Series Programming Manual page 183

4 AUXILIARY AND APPLIED FUNCTIONS
(2) Communication setting in MT Developer2 side
Set the items on the Transfer Setup screen in MT Developer2 as shown below.
2)
3)
1) Select [Ethernet Board] for PC side I/F.
2) Select [PLC Module] for CPU side I/F.
Select the "Connection via HUB" on the CPU side I/F Detailed Setting of PLC
Module screen, and set the Motion CPU IP address.
3) Make the setting for Other Station Setting.
Select it according to the operating environment.
4 - 68
1)
Select the "Connection
via HUB"
Set the Motion CPU
IP address