Mitsubishi Electric Q Series Programming Manual page 91

3 COMMON PARAMETERS
Item
Pulse/synchronous encoder
I/F module
High-speed
reading data
(Note-2)
PLC input module
Optional data monitor setting
QDS
Optional data monitor setting
QD
Mark detection setting QDS
High-speed input request signal
QDS Ver.!
Head module
QDS Ver.!
(Note-1): The forced stop can also be executed by the EMI forced stop terminal of Motion CPU module or forced stop terminal of
(Note-2): This cannot be set in SV22 advanced synchronous control.
(Note-3): This can be set only in SV22 advanced synchronous control.
(Note-4): This can be set only when "VC (Nikki Denso)" is selected in amplifier model.
Table 3.1 System data setting list (Continued)
Setting range
Either of Q172DEX and Q173DPX.
Q172DEX: Up to 2 points
Q173DPX: Up to 3 points
Either of one input module and built-in
interface in Motion CPU
Input module: Up to 8 points
Built-in interface in Motion CPU (DI):
<Communication type "SSCNET /H" use>
Set 1 to 6 for each axis.
<Communication type "SSCNET " use>
Set 1 to 3 for each axis.
Q173DSCPU: Up to 32 axes
Q172DSCPU: Up to 16 axes
Set 1 to 3 for each axis.
Q173DCPU(-S1): Up to 32 axes
Q172DCPU(-S1): Up to 8 axes
Set 1 to 32.
(Note-3)
Set 1 to 32.
Set module 1 to 4 for each line.
Q173DSCPU: 2 lines (Up to 8 modules)
Q172DSCPU: 1 line (Up to 4 modules)
servo amplifier besides the forced stop input setting.
Ver.! : Refer to Section 1.5 for the software version that supports this function.
Initial value
None
QDS
Up to 4 points
None
None
None
None
QDS
QDS
3 - 4
Remark
Refer to Section 4.3.
Refer to Section 4.10.
Refer to Section 4.14.
Refer to Section 4.15.
Refer to Section 4.18