Table of Contents
Advertisement
4.4
Software reset
Software reset is a function to reset the internal status of the servo amplifier and obtain the same effect as cycling the power.
By performing the software reset, the setting of the servo parameters can be reflected without cycling the power.
• In the case of an alarm caused by hardware failure, thermal protection or other factors, the alarm may not
be canceled even if the software reset is performed.
• When MR Configurator2 is connected to the servo amplifier via a network, reconnection may not be
possible if the software reset is performed after changing the setting of the network.
Precautions
• Canceling alarms is not the main purpose of the software reset function. Use of this function is not recommended for alarms
that would ordinarily be canceled by cycling the power.
Software reset in MR Configurator2
The servo amplifier can be reset with the software reset button in MR Configurator2.
Software reset via network communication
To perform a software reset from the controller, refer to the appropriate manual from the following list that matches the
network to be connected.
Network
CC-Link IE TSN
Reference manual
MR-JET-G User's Manual (Communication Function)
4 APPLICABLE FUNCTIONS
4.4 Software reset
4
103
Advertisement
Table of Contents
