Fba Settings - ABB ACSM1 Firmware Manual

176
Group

51 FBA SETTINGS

Further fieldbus communication configuration. These parameters need to be set only
if a fieldbus adapter module is installed. See also
page 343.
Notes:
• This parameter group is presented in the User's Manual of the fieldbus adapter as
parameter group 1 or A.
• The new settings will take effect when the drive is powered up the next time
(before powering off the drive, wait at least 1 minute), or when parameter
FBA PAR REFRESH
51
51.01 FBA TYPE
Displays the fieldbus protocol on the basis of the adapter module installed.
Not defined
(Fieldbus protocol)
51.02 FBA PAR2
... ....
51.26 FBA PAR26
Parameters 51.02...51.26 are adapter module-specific. For more information, see the User's Manual
of the fieldbus adapter module. Note that not all of these parameters are necessarily used.
51.27 FBA PAR REFRESH
Validates any changed adapter module configuration parameter settings. After refreshing, the value
reverts automatically to
Note: This parameter cannot be changed while the drive is running.
(0) DONE
(1) REFRESH
51.28 PAR TABLE VER
Displays the parameter table revision of the fieldbus adapter module mapping file stored in the
memory of the drive.
In format xyz, where x = major revision number; y = minor revision number; z = correction number.
51.29 DRIVE TYPE CODE
Displays the drive type code of the fieldbus adapter module mapping file stored in the memory of the
drive.
Example: 520 = ACSM1 Speed and Torque Control Program.
Parameters and firmware blocks
is activated.
FW block: None
Fieldbus adapter module not found (not properly connected, or
disabled by parameter
Fieldbus adapter for the stated protocol installed.
FW block: None
....
FW block: None
FW block: None
(0) DONE.
Refreshing done.
Refreshing.
FW block: None
FW block: None
Appendix A – Fieldbus control
50.01 FBA ENABLE).
on
51.27