ABB ACSM1 Firmware Manual page 98

98
12.02 DIO2 CONF
Selects whether DIO2 is used as a digital input, as a digital output or as a frequency input.
(0) Output
(1) Input
(2) Freq input
12.03 DIO3 CONF
Selects whether DIO3 is used as a digital input, as a digital output or as a frequency output.
(0) Output
(1) Input
(2) Freq output
12.04 DIO1 OUT PTR
Selects a drive signal to be connected to digital output DIO1 (when
Output).
Bit pointer: Group, index and bit
12.05 DIO2 OUT PTR
Selects a drive signal to be connected to digital output DIO2 (when
Output).
Bit pointer: Group, index and bit
12.06 DIO3 OUT PTR
Selects a drive signal to be connected to digital output DIO3 (when
Output).
Bit pointer: Group, index and bit
12.07 DIO3 F OUT PTR
Selects a drive signal to be connected to frequency output (when
output).
Value pointer: Group and index
12.08 DIO3 F MAX
When
3...32768 Hz
12.09 DIO3 F MIN
When
3...32768 Hz
Parameters and firmware blocks
FW block:
DIO2 is used as a digital output.
DIO2 is used as a digital input.
DIO2 is used as a frequency input.
FW block:
DIO2 is used as a digital output.
DIO2 is used as a digital input.
DIO2 is used as a frequency output.
FW block:
FW block:
FW block:
FW block:
FW block:
12.03 DIO3 CONF is set to
Maximum DIO3 output frequency.
FW block:
12.03 DIO3 CONF is set to
Minimum DIO3 output frequency.
DIO2 (see above)
DIO3 (see above)
DIO1 (see above)
DIO2 (see above)
DIO3 (see above)
DIO3 (see above)
DIO3 (see above)
(2) Freq output, defines the maximum DIO3 output frequency.
DIO3 (see above)
(2) Freq output, defines the minimum DIO3 output frequency.
12.01 DIO1 CONF is set to
12.02 DIO2 CONF is set to
12.03 DIO3 CONF is set to
12.03 DIO3 CONF is set to
(0)
(0)
(0)
(2) Freq