ABB ACSM1 Firmware Manual page 345

Parameter
51.32 FBA COMM SW
VER
51.33 FBA APPL SW
VER
Note: In the User's Manual of the fieldbus adapter module, the parameter group number is 1 or A for parameters
51.01...51.26.
52.01 FBA DATA IN1
... 52.12 FBA DATA
IN12
53.01 FBA DATA
OUT1 ... 53.12 FBA
DATA OUT12
Note: In the User's Manual of the fieldbus adapter module, the parameter group number is 2 or B for parameters
52.01...52.12 and 3 or C for parameters 53.01...53.12.
After the module configuration parameters have been set, the drive control
parameters (see section
checked and adjusted when necessary.
The new settings will take effect when the drive is powered up the next time, or when
parameter
Setting for
fieldbus control
– Displays the common program revision of the adapter module.
– Displays the application program revision of the adapter module.
TRANSMITTED DATA SELECTION
0 Defines the data transmitted from drive to fieldbus controller.
4...6
Note: If the selected data is 32 bits long, two parameters are reserved
14...16
for the transmission.
101...9999
0 Defines the data transmitted from fieldbus controller to drive.
1...3
Note: If the selected data is 32 bits long, two parameters are reserved
11...13
for the transmission.
1001...9999
Setting the drive control parameters
51.27 FBA PAR REFRESH is activated.
Function/Information
below) must be
Appendix A – Fieldbus control
345