Fba A Settings - ABB ACQ80-04 Firmware Manual

146 Parameters
No. Name/Value
50.18 FBA A actual value
2
51

51 FBA A settings

51.01 FBA A type
51.02 FBA A Par2
0...65535
... ...
51.26 FBA A Par26
0...65535
51.27 FBA A par refresh
Done
Configure
51.28 FBA A par table ver
0x0000...0xffff
51.29 FBA A drive type
code
0...65535
51.30 FBA A mapping file
ver
0...65535
51.31 D2FBA A comm
status
Not configured
Initializing
Description
Not applicable
Fieldbus adapter A configuration.
Shows type of the connected fieldbus adapter module.
0 = Module is not found or is not properly connected, or is
disabled by parameter 50.01 FBA A
0 = None
1 = PROFIBUS-DP
32 = CANopen
128 = Ethernet
132 = PROFInet IO
135 = EtherCAT
485 = RS-485 comm
502 = Modbus/TCP
2222 = Ethernet/IP
This parameter is read-only.
Parameters 51.02...51.26
more information, see the documentation of the fieldbus
adapter module. Note that not all of these parameters are
necessarily in use.
Fieldbus adapter configuration parameter.
...
See parameter 51.02 FBA A
Fieldbus adapter configuration parameter.
Validates any changed fieldbus adapter module configuration
settings. After refreshing, the value reverts automatically to
Done.
Note: This parameter cannot be changed while the drive is
running.
Refreshing done.
Refreshing.
Shows parameter table revision of the fieldbus adapter
module mapping file (stored in the memory of the drive).
In format axyz, where ax = major table revision number; yz =
minor table revision number.
This parameter is read-only.
Parameter table revision of adapter module.
Shows drive type code in the fieldbus adapter module
mapping file (stored in the memory of the drive).
This parameter is read-only.
Drive type code stored in the mapping file.
Shows fieldbus adapter module mapping file revision stored
in the memory of the drive in decimal format.
This parameter is read-only.
Mapping file revision.
Shows status of the fieldbus adapter module communication.
Adapter is not configured.
Adapter is initializing.
enable.
are adapter module-specific. For
Par2.
Def/FbEq16
0
0
1 = 1
...
0
1 = 1
Done
0
1
0x0000
-
-
1 = 1
-
1 = 1
Not
configured
0
1