Group 08 Alarms & Faults; Group 06 Drive Status - ABB ACSM1 Firmware Manual

76
Group 06 DRIVE STATUS
06
6.01 STATUS WORD 1
Status word 1.
Bit
0
1
2
3
4
5
6
7
8
9
10
11
12
13...15 Reserved
Parameters and firmware blocks
FW block:
Name Val.
READY 1
0
ENABLED 1
0
STARTED 1
0
RUNNING 1
0
EM OFF (OFF2) 1
0
EM STOP 1
(OFF3)
0
ACK STARTINH 1
0
ALARM 1
0
EXT2 ACT 1
0
LOCAL FB 1
0
FAULT 1
0
LOCAL PANEL 1
0
NOT FAULTED 1
0
DRIVE LOGIC (page 88)
Drive is ready to receive start command.
Drive is not ready.
External run enable signal is received.
No external run enable signal is received.
Drive has received start command.
Drive has not received start command.
Drive is modulating.
Drive is not modulating.
Emergency OFF2 is active.
Emergency OFF2 is inactive.
Emergency stop OFF3 (ramp stop) is active.
Emergency OFF3 is inactive.
Start inhibit is active.
Start inhibit is inactive.
An alarm is active. See chapter
No alarm
External control EXT2 is active.
External control EXT1 is active.
Fieldbus local control is active.
Fieldbus local control is inactive.
A fault is active. See chapter
No fault
Local control is active, ie, drive is controlled from PC tool or con-
trol panel.
Local control is inactive.
No fault
A fault is active. See chapter
Information
Fault tracing.
Fault tracing.
Fault tracing.