Group 33 Supervision - ABB ACSM1 Firmware Manual

Group 33 SUPERVISION
Configuration of signal supervision.
33
Firmware block:
SUPERVISION
(17)
Block outputs located in other
parameter groups
33.01 SUPERV1 FUNC
Selects the mode of supervision 1.
(0) Disabled
(1) Low
(2) High
(3) Abs Low
(4) Abs High
33.02 SUPERV1 ACT
Selects the signal to be monitored by supervision 1. See parameter
Value pointer: Group and index
SUPERVISION
6.14 SUPERV STATUS (page 79)
FW block: SUPERVISION
Supervision 1 not in use.
When the signal selected by parameter
below the value of parameter
SUPERV STATUS is activated. To clear the bit, the signal must
exceed the value of parameter
When the signal selected by parameter
exceeds the value of parameter
SUPERV STATUS is activated. To clear the bit, the signal must fall
below the value of parameter
When the absolute value of the signal selected by parameter
SUPERV1 ACT falls below the value of parameter
LIM LO, bit 0 of 6.14 SUPERV STATUS
the absolute value of the signal must exceed the value of parameter
33.03 SUPERV1 LIM HI.
When the absolute value of the signal selected by parameter
SUPERV1 ACT exceeds the value of parameter
HI, bit 0 of 6.14 SUPERV STATUS
absolute value of the signal must fall below the value of parameter
33.04 SUPERV1 LIM LO.
FW block: SUPERVISION
(see above)
33.02 SUPERV1 ACT
33.04 SUPERV1 LIM
33.03 SUPERV1 LIM
33.02 SUPERV1 ACT
33.03 SUPERV1 LIM
33.04 SUPERV1 LIM
33.04 SUPERV1
is activated. To clear the bit,
33.03 SUPERV1 LIM
is activated. To clear the bit, the
(see above)
33.01 SUPERV1
Parameters and firmware blocks
145
falls
LO, bit 0 of 6.14
HI.
HI, bit 0 of 6.14
LO.
33.02
33.02
FUNC.