ABB ACSM1 Firmware Manual page 85

8.17 ALARM WORD 3
Alarm word 3. For possible causes and remedies, see chapter
refreshed, ie, when the alarm goes off, the corresponding alarm bit is cleared from the signal.
Bit Alarm
0 ENCODER 2 CABLE
1 D2D COMM
2 D2D BUF OVLOAD
3 PS COMM
4 RESTORE
5 CUR MEAS CALIB
6 AUTOPHASING
7 EARTH FAULT
8 Reserved
9 MOTOR NOM VALUE
10 D2D CONFIG
11 STALL
12...14 Reserved
15 SPEED FEEDBACK
8.18 ALARM WORD 4
Alarm word 4. For possible causes and remedies, see chapter
refreshed, ie, when the alarm goes off, the corresponding alarm bit is cleared from the signal.
Bit Alarm
0 OPTION COMM LOSS
1 SOLUTION ALARM
2...5 Reserved
6 PROT. SET PASS
7...8 Reserved
9 DC NOT CHARGED
10 SPEED TUNE FAIL
11...15 Reserved
FW block: FAULT FUNCTIONS
FW block: FAULT FUNCTIONS
(page 163)
Fault tracing. This alarm word is
(page 163)
Fault tracing. This alarm word is
Parameters and firmware blocks
85