Switch - ABB ACSM1 Firmware Manual

326
Operation
Inputs
Outputs

SWITCH

(10063)
Illustration
Execution time
Operation
Inputs
Outputs
Standard function blocks
The input (I) value is stored to the output (OA1...OA32) selected by the address input
(A) if the load input (L) or the set input (S) is 1. When the load input is set to 1, the input
(I) value is stored to the output only once. When the set input is set to 1, the input (I)
value is stored to the output every time the block is executed. The set input overrides
the load input.
If the reset input (R) is 1, all connected outputs are 0.
If the address input is 0, negative or exceeds the number of the outputs, all outputs
are 0.
Example:
S L R
1 0 0
0 0 0
0 1 0
1 0 0
1 1 0
1 1 1
The input data type is selected by the user.
Address input (A): DINT
Reset input (R): Boolean
Load input (L): Boolean
Set input (S): Boolean
Input (I): DINT, INT, REAL, REAL24, Boolean
The number of the output channels (1...32) is selected by the user.
Output (OA1...OA32): DINT, INT, REAL, REAL24, Boolean
0.68 µs (when two inputs are used) + 0.50 µs (for every additional input). When all
inputs are used, the execution time is 15.80 µs.
The output (OUT) is equal to the corresponding input (IN) if the activate input (ACT) is 1.
Otherwise the output is 0.
The input data type and the number of inputs (1...32) are selected by the user.
Activate input (ACT): Boolean
Input (IN1...IN32): INT, DINT, REAL, REAL24, Boolean
Output (OUT1...OUT32): INT, DINT, REAL, REAL24, Boolean
A I OA1
2 150 0
2 120 0
3 100 0
1 200 200
4 250 200
2 300 0
OA2 OA3 OA4
150 0 0
150 0 0
150 100 0
150 100 0
150 100 250
0 0 0