14
Contents
The manual consists of the following chapters:
•
Start-up
through the I/O interface.
•
Drive programming using PC tools
(DriveStudio and/or DriveSPC).
•
Drive control and features
the drive, and the features of the application program.
•
Default connections of the control unit
JCU Control Unit.
•
Parameters and firmware blocks
function blocks.
•
Parameter data
•
Fault tracing
remedies.
•
Standard function blocks
•
Application program template
•
Appendix A – Fieldbus control
and a fieldbus.
•
Appendix B – Drive-to-drive link
connected together by the drive-to-drive link.
•
Appendix C – Control chain and drive logic
Product and service inquiries
Address any inquiries about the product to your local ABB representative, quoting
the type code and serial number of the unit in question. A listing of ABB sales,
support and service contacts can be found by navigating to
selecting Drives – Sales, Support and Service network.
Product training
For information on ABB product training, navigate to
Drives – Training courses.
Providing feedback on ABB Drives manuals
Your comments on our manuals are welcome. Go to
Document Library – Manuals feedback form (LV AC drives).
Introduction to the manual
instructs in setting up the control program and how to control the drive
describes the control locations and operation modes of
contains more information on the parameters of the drive.
lists the warning and fault messages with the possible causes and
introduces programming via PC tool
presents the default connections of the
describes the drive parameters and firmware
describes the communication between the drive
describes the communication between drives
diagrams.
www.abb.com/drives
www.abb.com/drives
www.abb.com/drives
and select
and select
and