Output Signal Allocations - YASKAWA E-V Series User Manual

3 Wiring and Connection

3.3.2 Output Signal Allocations

Step
11
12
<Input signal polarities>
Input signal polarities are as follows when sequence input circuit is connected to a sink circuit. If connected to
a source circuit, polarities are reversed. For details, refer to 3.4.2 Connection Examples of Sequence Input
Circuits to SERVOPACK.
Signal
ON
OFF
(4) Checking Input Signals
Input signal status can be checked using the input signal monitor (Un005). As for the input signal monitor
(Un005), refer to 8.6 Monitoring Input Signals.

3.3.2 Output Signal Allocations

Output signals can be allocated to I/O signal connectors (CN1) in accordance with the parameter setting of
Pn50E, Pn50F, Pn510 and Pn512.
(1) Factory Setting
Factory setting can be checked using the following parameters.
Pn50E
Pn50F
Pn510
3-28
Display after
Operation
MODE/SET
Turn the power OFF and ON again to enable the change of input signal selections (Pn50A and Pn50B)
Level
Low (L) level
High (H) level
Allocates /COIN signal to CN1-25, -26.
Allocates /V-CMP signal to CN1-25, -26.
Allocates /TGON signal to CN1-27, -28.
Allocates /S-RDY signal to CN1-29, -30.
Not to use /CLT signal.
Not to use /VLT signal.
Not to use /BK signal.
Not to use /WARN signal.
Not to use /NEAR signal.
Reserved (Cannot be changed)
Reserved (Cannot be changed)
Reserved (Cannot be changed)
Keys
Press the DATA/SHIFT Key for approximately one second to
return to the display Pn50B. /S-ON is mapped on CN1-45,
and /P-CL is mapped on CN1-40.
DATA/
Voltage Level Contact
0 V Close
24 V Open
Description