YASKAWA E-V Series User Manual page 103

4 Trial Operation
4.5.4 Operator Display during Testing without Motor
The test without motor status is not displayed in the following status.
A.
AdJ
(Blinks)
no_oP
(Blinks one second)
Error
(Blinks one second)
done
(Blinks one second)
End
(Blinks one second)
(2) Display on Digital Operator
∗ mark is displayed before status display to indicate the test without motor operation is in progress.
∗ B B
U n 0 0 0 =
U n 0 0 2 =
U n 0 0 8 =
U n 0 0 D =
(Example: Status of power to the motor is OFF)
*RUN
*BB
*P DET
*PT NT
*P-OT
*N-OT
*HBB
The test without motor status is not displayed in the following status.
A.
AdJ
(Blinks)
NO_OP
(Blinks one second)
ERROR
(Blinks one second)
doNE
(Blinks one second)
END
(Blinks one second)
4-8
Display
Alarm occurs.
Executing advanced autotuning (Fn201).
Utility function disabled.
Error occurs during executing the utility function.
Utility function executed correctly.
Program JOG operation executed correctly.
− P R M / M O N −
0 0 0 0 0 0
0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0 0
Display
Power is supplied to the motor.
Power to the motor is OFF.
The polarity is being detected.
Forward or reverse run is prohibited.
Driving in the forward direction is prohibited.
Driving in the reverse direction is prohibited.
In hard-wire base block (safety) state.
Display
Alarm occurs.
Executing advanced autotuning (Fn201).
Utility function disabled.
Error occurs during executing the utility function.
Utility function executed correctly.
Program JOG operation executed correctly.
Status
Status
Status