YASKAWA E-V Series User Manual page 79

(3) Example of Output Signal Allocation
The procedure to set Movement Detection (/TGON) signal of factory setting to
Interlock (/BK) signal is shown below.
Pn50E
Display after
Step
Operation
1
2
3
4
Display blinks.
5
6
7
8
9
Display blinks.
10
11 Turn the power OFF and ON again to enable the changes of output signal selection (Pn50E and Pn50F).
(4) Checking Output Signals
Output signal status can be checked using the output signal monitor (Un006). As for the output signal monitor
(Un006), refer to 8.7 Monitoring Output Signals.
Pn50F
Before
After
Keys
Press the MODE/SET Key to select the parameter setting
mode. If a parameter other than Pn50E is displayed, press
the UP or DOWN Key to select Pn50E.
MODE/SET DATA/
Press the DATA/SHIFT Key for approximately one second
to display the current data of Pn50E.
(/TGON is allocated on CN1-27 (28).)
MODE/SET DATA/
Press the DATA/SHIFT Key to select the third digit from
the right. Press the DOWN Key to set "0."
(Sets /TGON "Invalid.")
MODE/SET DATA/
Press the MODE/SET Key.
The data blinks and is saved.
MODE/SET DATA/
Press the DATA/SHIFT Key for approximately one second
to return to the display Pn50E.
MODE/SET DATA/
Press the UP Key to display Pn50F.
MODE/SET DATA/
Press the DATA/SHIFT Key for approximately one second
to display the current data of Pn50F.
(/BK is set to "Invalid.")
MODE/SET DATA/
Press the DATA/SHIFT Key to select the third digit from
the right. Press the UP Key to set "2."
(Allocates /BK to CN1-27 (28).)
MODE/SET DATA/
Press the MODE/SET Key.
The value blinks and is saved.
MODE/SET DATA/
Press the DATA/SHIFT Key for approximately one second
to return to the display Pn50F. /TGON is set as "Invalid"
and /BK is allocated on CN1-27 (28).
MODE/SET DATA/
3.3 I/O Signal Allocations
Invalid and allocate Brake
" "
Description
3
3-31