YASKAWA E-V Series User Manual page 23

Interface
RS422A
1:N
Communi-
Communica-
cations
tions
(CN3)
Communi-
cations Axis Address
Function Setting
Interface
USB
Communi-
Communica-
cations
tions Stan-
(CN7)
dard
LED Display
Analog Monitor (CN5)
Dynamic Brake (DB)
Regenerative Processing
Overtravel Prevention (OT)
Protection Function
Utility Function
Input
Safety Function
Output
Option Module
∗1. Rack mounting and duct-ventilated type available as an option.
∗2. Speed regulation by load regulation is defined as follows:
No-load motor speed
Speed regulation =
Digital operator (JUSP-OP05A-1-E), personal computer (can be connected with
SigmaWin+), etc.
N = Up to 15 stations possible at RS422A
Set by parameter
Personal computer (can be connected with SigmaWin+.)
Complies with standard USB1.1. (12 Mbps)
Panel display (five 7 segment) and CHARGE indicator
Number of points: 2
Output voltage: ± 10V DC (linearity effective range ± 8V)
Resolution: 16 bit
Accuracy: ± 20 mV (Typ)
Max. output current: ± 10 mA
Settling time (± 1%): 1.2 ms (Typ)
Operated at main circuit power supply OFF, servo alarm, servo OFF or over-
travel
Built-in or external regenerative resistor (option)
Dynamic brake stop at P-OT or N-OT, deceleration to a stop, or free run to a stop
Overcurrent, overvoltage, insufficient voltage, overload, regeneration error, and
so on.
Gain adjustment, alarm history, JOG operation, origin search, and so on.
/HWBB1, /HWBB2: Baseblock signal for power module
EDM1: Monitoring status of internal safety circuit (fixed output)
Fully-closed option module
- Total load motor speed
Rated motor speed
1.3 SERVOPACK Ratings and Specifications
×
100%
1
1-5