Examples Of Servo System Configurations; Connecting To Sgdv- F05A Servopack - YASKAWA E-V Series User Manual

1.5

Examples of Servo System Configurations

This section describes examples of basic servo system configuration.
1.5.1 Connecting to SGDV-
Power supply
Single-phase 100 VAC
R T
Molded-case
circuit breaker
(MCCB)
Protects the power supply
line by shutting the
circuit OFF when
overcurrent is
detected.
Noise filter
Used to eliminate
external noise from
the power line.
Regenerative
resistor*
Main circuit cable
for linear servomotor
∗
Before connecting an external regenerative resistor to the SERVOPACK, refer to 3.6 Connecting Regenerative Resis-
tors.
F05A SERVOPACK
SGDV- F05A
SERVOPACK
Magnetic
contactor
Turns the servo
ON and OFF.
Install a surge
absorber.
Connection cable for
serial converter unit
Serial converter unit
Encoder
cable
Linear scale
(not included)

1.5 Examples of Servo System Configurations

Personal
Connection cable
computer
for digital operator
Connection cable
for personal computer
Host controller
I/O signal cable
When not using the safety
function, use the SERVOPACK
with the safety function jumper
connector (JZSP-CVH05-E,
provided as an accessory)
inserted.
When using the safety function,
insert a connection cable
specifically for the safety function.
Safety function
devices
Connection cable
for hall sensor
Linear servomotor with core
Digital
operator
1
1-15