Suzuki SY413 Service Manual page 2526

CODE 43 – DRIVER PRETENSlONER INITIATOR CIRCUIT SHORT TO GROUND
CODE 47 – PASSENGER PRETENSIONER INITIATOR CIRCUIT SHORT TO GROUND
(Page 2 of 2)
NOTE:
Before executing items in this table, be sure to perform "AIR BAG DIAGNOSTIC CHECK FLOW TABLE".
STEP
1 1) With ignition switch OFF, remove center pillar
inner garnish of applicable side then disconnect
seat belt pretensioner connector.
2) Check proper connection to applicable seat belt
pretensioner at terminals in "G" or "H" connec-
tor.
3) If OK then connect special tool (B) to seat belt
pretensioner connector disconnected at the
Step 1.
With ignition switch ON, is DTC 43 or 47 still cur-
rent?
2 1) With ignition switch OFF, disconnect special
tool (B) and SDM.
2) Measure resistance between "A13" or "A11"
and "A10" terminals.
Is resistance 1 kW or more?
Fig. for STEP 1 and 2
Special Tool
(B): 09932-75010
1. "STEERING WHEEL"
NOTE:
Upon completion of inspection and repair work, perform the following procedure.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to "DIAGNOSTIC TROUBLE CODE (DTC) CLEARANCE"), if any.
3) Repeat "AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE" to confirm that the trouble has been
corrected.
ACTION
Fig. for STEP 2
For DTC 43
YES
Go to Step 2.
Substitute a known-
good SDM and re-
check.
For DTC 47
Special Tool
(A): 09932-76010
AIR BAG SYSTEM 9J-57
NO
1) Ignition switch OFF.
2) Replace seat belt
pretensioner.
DTC 43 :
Repair short "P" or "W"
wire circuit to ground.
DTC 47:
Repair short from "Lg" or
"Br" wire circuit to
ground.