Table of Contents
Advertisement
9A-184 Wiring Systems:
2. Locate the nose piece locking tabs that are
positioned on the side of the connector nose piece.
The connector nose piece acts as a terminal positive
assurance (TPA) and may be referred to as such.
3. Use a small flat-blade tool to push in one of the
locking tabs while gently pulling on the same side of
the nose piece.
4. Repeat the procedure for the other locking tab and
remove the nose piece.
5. Remove the wire dress cover. The following is a
general procedure for wire dress cover removal. Use
this procedure as a guide, some dress cover
removal procedures may vary.
6. Use fingers to squeeze the 2 locking legs of the
cover.
7. Apply pressure and gently rock the cover until one
locking leg is unseated.
Advertisement
Table of Contents
Troubleshooting
