Table of Contents
Advertisement
3. Use a small flat-blade tool to remove the dress
cover.
4. Slide the dress cover forward and off of the
connector.
5. The terminal positive assurance (TPA) is located in
the front and rear of the connector.
6. Use a small flat-blade tool to remove the rear TPA
from the connector.
NOTE
The front TPA cannot be removed from the
connector. Only move it to the release point.
7. Use a small flat-blade tool to move the front TPA to
the release position.
8. Use the J 38125-213 or the J 38125-560 (GM P/N
15314260) tool to release the terminals by inserting
the tool into the terminal release cavity. See the
release tool cross reference in the Reference Guide
of the J-38125 to ensure that the correct release tool
is used.
9. While holding the removal tool in place, gently pull
the wire out of the back of the connector. Always
remember never use force when pulling a terminal
out of a connector.
Wiring Systems:
9A-195
Advertisement
Table of Contents
Troubleshooting
