Mazda RX-8 Manual page 2311

Hide thumbs Also See for RX-8:

Table of Contents

Pre-tensioner Seat Belt Connector Removal Note

1. Using a flathead screwdriver, pry out the pre-tensioner seat belt connector stopper plate.

2. Disconnect the pre-tensioner seat belt connector.

LOCK RELEASE SOLENOID INSPECTION

1. Disconnect the negative battery cable.

2. Remove the rear door lower trim. (See REAR DOOR LOWER TRIM REMOVAL/INSTALLATION .)

3. Disconnect the lock release solenoid connector.

4. Measure the resistance of the lock release solenoid individually.

If not within the specification, replace the front seat belt.

Troubleshooting