Diagnostic procedure
STEP INSPECTION
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
Has FREEZE FRAME DATA been
•
recorded?
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins and/or
•
2
on-line repair information availability.
Is any related repair information
•
available?
VERIFY RELATED PENDING CODE OR
STORED DTC
Turn the ignition switch off, then to the
•
3
ON position (Engine off).
Verify the related PENDING CODE or
•
stored DTCs.
Are other DTCs present?
•
IDENTIFY TRIGGER DTC FOR FREEZE
FRAME DATA
4
Is DTC P2196 on FREEZE FRAME
•
DATA?
VERIFY CURRENT INPUT SIGNAL
STATUS
Connect the WDS or equivalent to the
•
DLC-2.
Verify the following PIDs.
•
5
(See PCM INSPECTION .)
ECT
MAF
O2S12
RPM
Are the PIDs normal?
•
ACTION
Yes Go to the next step.
Record the FREEZE FRAME DATA on the
No
repair order, then go to the next step.
Perform repair or diagnosis according to the
available repair information.
Yes
If the vehicle is not repaired, go to the
•
next step.
No Go to the next step.
Go to the appropriate DTC inspection.
Yes
(See DTC TABLE .)
No Go to the next step.
Yes Go to the next step.
Go to the FREEZE FRAME DATA DTC
inspection.
No
(See DTC TABLE .)
Yes Go to the next step.
Inspect the malfunctioning part according to the
inspection results.
No
Then go to Step 10.
(w)
Engine Diagnostics & Control
Page 401