Mazda RX-8 Manual page 1006

Diagnostic procedure
STEP INSPECTION
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
Has FREEZE FRAME DATA been
•
recorded?
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins and/or
•
2
on-line repair information availability.
Is any related repair information
•
available?
INSPECT EVAP SYSTEM LEAK
DETECTION PUMP
Inspect the EVAP system leak detection
•
pump.
3
(See EVAPORATIVE EMISSION
(EVAP) SYSTEM LEAK
DETECTION PUMP INSPECTION .)
Is there any malfunction ?
•
VERIFY TROUBLESHOOTING OF DTC
P2405 COMPLETED
Make sure to reconnect all disconnected
•
connectors.
Clear the DTC from the PCM memory
•
using the WDS or equivalent.
4
Perform the DRIVE MODE 1 and 6.
•
(See OBD-II DRIVE MODE )
Is the PENDING CODE same as DTC
•
present?
5 VERIFY AFTER REPAIR PROCEDURE
ACTION
Yes Go to the next step.
Record the FREEZE FRAME DATA on the
No
repair order, then go to the next step.
Perform repair or diagnosis according to the
available repair information.
Yes
If the vehicle is not repaired, go to the next
•
step.
No Go to the next step.
Replace the EVAP system leak detection pump,
then go to the next step.
Yes
(See EVAPORATIVE EMISSION (EVAP)
CONTROL SYSTEM
REMOVAL/INSTALLATION .)
No Go to the next step.
Replace the PCM, then go to the next step.
Yes
(See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
Go to the applicable DTC inspection.
Yes
(See DTC TABLE .)
(w) Engine Diagnostics & Control
Page 443