Subaru Impreza 2002 Service Manual page 545

BRAKE
5. Rear Brake Pad
A: REMOVAL
3. 17 INCH TYPE
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Jack-up the vehicle, and then remove the front
wheel.
4) Remove the clip.
(1) Clip
5) Remove the pad pins and cross spring.
(1) Cross spring
(2) Pad pin
6) Expand the pads and push piston back.
7) Remove the pad.
(1) Rear brake pad
REAR BRAKE PAD
B: INSTALLATION
3. 17 INCH TYPE
1) Apply a thin coat of Molykote AS880N (Part No.
26298AC000) to frictional portion between pad and
pad inner shim.
2) Install the pads on caliper body.
3) Install the cross spring and pad pins.
4) Install the Clip.
C: INSPECTION
3. 17 INCH TYPE
Check the pad thickness A.
(1)
BR0148
Pad thickness
(including back
metal)
CAUTION:
• Always replace the pads for both right and
left wheels at the same time. Also replace the
pad clips if they are twisted or worn.
• A wear indicator is provided on the outer disc
brake pad. If the pad wears down to such an ex-
BR0019
tent that the end of wear indicator contacts the
disc rotor, a squeaking sound is produced as
the wheel rotates. If this sound is heard, replace
the pad.
• Replace the pad if there is oil or grease on it.
BR0020
BR-12
A
BR0021
Standard value 13.5 mm (0.531 in)
Wear limit 6.2 mm (0.244 in)