Subaru Impreza 2002 Service Manual page 334

22) Remove the fixing bolt of engine and transmis-
sion, then remove the transmission from vehicle.
NOTE:
• Rotate the ST (ENGINE SUPPORT ASSY)
counterclockwise (to shorter the ST) and lower the
rear side of engine to facilitate removal.
• Take care not to contact the transmission with
body when pulling backward to remove.
• Remove carefully. The clutch pipe and breather
pipe may interfere each other.
B: INSTALLATION
1) Set the release fork, release bearing and release
shaft to transmission. <Ref. to CL-26, INSTALLA-
TION, Release Bearing and Lever.>
2) Install the transmission.
NOTE:
• Make sure the main shaft spline part is inserted
completely.
• Make sure the rear side of engine is lowered.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
MANUAL TRANSMISSION ASSEMBLY
TR0645
TR0646
B2M2790
6MT-39
MANUAL TRANSMISSION AND DIFFERENTIAL
3) Move the transmission to the right side, then in-
stall the joint COMPL bolt, stay bolt and reverse
check cable.
Tightening torque:
T1: 11.8 N·m (1.2 kgf-m, 8.7 ft-lb)
T2: 32 N·m (3.3 kgf-m, 23.6 ft-lb)
(A)
T1
T2
(A) Reverse check cable
4) Install the front crossmember and rear cross-
member.
NOTE:
Rotate the ST (ENGINE SUPPORT ASSY) turn
buckle clockwise (make longer the ST) and lift up
the rear side of engine to facilitate installation.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
5) Lower the vehicle and install the fixing bolt.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
TR0647
TR0648
B2M2791