Subaru Impreza 2002 Service Manual page 953

MECHANICAL
3) Temporarily tighten the 10 mm cylinder block
connecting bolts in alphabetical sequence shown in
the figure.
4) Tighten the 10 mm cylinder block connecting
bolts in alphabetical sequence.
Tightening torque:
47 N·m (4.8 kgf-m, 34.7 ft-lb)
5) Tighten the 8 mm and 6 mm cylinder block con-
necting bolts in alphabetical sequence shown in the
figure.
Tightening torque:
(A) — (G): 25 N·m (2.5 kgf-m, 18.1 ft-lb)
(H): 6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
CYLINDER BLOCK
6) Install the rear oil seal using ST1 and ST2.
ST1 499597100
ST2 499587200
B2M0088D
7) Position the top ring gap at (A) or (B) in the fig-
ure.
8) Position the second ring gap at 180° on the re-
verse side for top ring gap.
• 1600 cc MODEL
B2M0088D
• 2000 cc MODEL
B2M0089F
ME-76
OIL SEAL GUIDE
OIL SEAL INSTALLER
(A) Rear oil seal
(B) Fly wheel attaching bolt
180˚
B0SH
S2M1827A
H2M3248
B2M4617A