Subaru Impreza 2002 Service Manual page 381

MANUAL TRANSMISSION AND DIFFERENTIAL
3) Measure the height to edge surface of ball bear-
ing (height A1).
(A)
(A) Ball bearing
NOTE:
Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
bearing.
Measure five points of the ball bearing turning ev-
ery approx. 120°. Round off each two upper and
lower measurement value. Use the remaining cen-
ter value as measurement value.
MAIN SHAFT ASSEMBLY
TR0757
(2)
(1)
TR0758
6MT-86
4) According to measurement value, select the
snap ring and washer from the following table.
Snap ring
A1: mm (in) Part No.
270.83 — 271.40
805072010
(10.66 — 10.69)
271.41 — 271.98
805072011
(10.69 — 10.71)
271.99 — 272.56
805072012
(10.71 — 10.73)
Washer
A1: mm (in) Part No.
270.83 — 271.40
803067012
(10.66 — 10.69)
271.41 — 271.98
803067011
(10.69 — 10.71)
271.99 — 272.56
803067010
(10.71 — 10.73)
Thickness: mm
(in)
1.65
(0.065)
1.95
(0.077)
2.25
(0.089)
Thickness: mm
(in)
1.6
(0.063)
1.3
(0.051)
1.0
(0.039)