Subaru Impreza 2002 Service Manual page 171

MECHANICAL
9. Engine Assembly
A: REMOVAL
1) Set the vehicle on lift arms.
2) Open the front hood fully and support with stay.
3) Raise the rear seat, and turn floor mat up.
4) Release the fuel pressure.
(1) Disconnect the fuel pump relay connector.
(2) Start the engine, and run until it stalls.
(3) After the engine stalls, crank it for five sec-
onds more.
(4) Turn the ignition switch to "OFF".
5) Remove the filler cap.
6) Disconnect the battery ground terminal.
7) Remove the radiator from vehicle. <Ref. to CO-
39, REMOVAL, Radiator.>
8) Remove the coolant filler tank. <Ref. to CO-53,
REMOVAL, Coolant Filler Tank.>
9) Collect the refrigerant, and remove the pressure
hoses.
(1) Place and connect the attachment hose to
the refrigerant recycle system.
(2) Collect the refrigerant from A/C system.
ENGINE ASSEMBLY
(3) Disconnect the A/C pressure hoses from
A/C compressor.
10) Remove the intercooler. <Ref. to IN(TURBO)-
10, REMOVAL, Intercooler.>
11) Disconnect the following connectors and cable.
(1) Engine harness connector
EN0344
(2) Engine ground terminal
G6M0095
(3) Engine harness connector
ME(STi)-32
S2M1584
S2M1929
S2M0731
S2M1930