Subaru Impreza 2002 Service Manual page 422

M.SFT
Snap ring
T mm (in)
805072010
[t=1.65 mm
(0.065 in)]
137.22—
137.52 32809AA171
(5.4024— (None)
5.4142)
137.52—
137.82 32809AA161
(5.4142— (1)
5.4260)
137.82—
138.12 32809AA141
(5.4260— (3)
5.4379)
T = Thickness
3. SELECTION OF 5TH
NOTE:
Perform the following procedures when:
• Replacing the main shaft.
• Replacing the 3rd to 6th drive gear and bush.
• Replacing the 3rd to 6th synchro ring assembly.
1) Insert the main shaft assembly in adapter plate.
2) Set the height gauge to adapter plate. Lower the
indicator of height gauge to upper surface of snap
ring groove, or the upper side of main rear bearing.
Then set to zero point.
ST 18853AA000 HEIGHT GAUGE
(A) Ball bearing
SHIFTER FORK AND ROD
Lot No. (Mark)
M.SFT M.SFT
Snap ring Snap ring
805072011 805072012
[t=1.95 mm [t=2.25 mm
(0.077 in)] (0.089 in)]
32809AA181 32809AA191
(2) (4)
32809AA171 32809AA181
(None) (2)
32809AA161 32809AA171
(1) (None)
6TH FORK ROD
-
(A)
TR0862
6MT-127
MANUAL TRANSMISSION AND DIFFERENTIAL
NOTE:
• Remove the remaining gasket on edge surface
with scraper, since the height gauge is set on
adapter plate during measurement.
• Do not place the height gauge on shaded area in
the figure during the measurement.
3) Using the height gauge, measure "D1" and "D2"
shown in the figure.
D2
D1
(A) 5th main gear
(B) 6th main gear
TR0756
(B)
(A)
TR0867